#025B-16 - Boost Liquid Fortifier (16 oz)

Bulletproof foam? Not yet, but this is about as close as you will get. When Boost liquid fortifier is mixed with our Foam Coat it makes it incredibly strong and weatherproof, plus makes it stick to almost anything! Use 16oz of Boost with 6-25 pounds of our Foam Coat.

MIXING: Mix with 50% water for maximum strength. Thin more where less strength is needed. Always add the Foam Coat to the liquid. Start with 1 part liquid to 3 parts Foam Coat, and thin or thicken as desired. Thinning the Foam Coat with more Boost will not weaken it.
APPLYING: Fill large cracks and holes with pasty mixture. To coat large areas, add more liquid until thin enough to apply with a paint brush. May be applied as thick as 3/8 inch, but multiple coats are stronger. Try texturing surface before coating sets.
SET TIME: Use within 10 minutes. Sets hard in 30 minutes. Add acrylic paint to extend use time. Maximum bond and hardness in 24 hours.
CLEAN-UP: Immediately clean tools and brushes with soapy water. Boost cannot be removed once dry.
FINISHING: May be painted or stained.

Suggested Dilutions Boost/Water:
Super Strong: 1:1
Very Strong: 1:2
Strong: 1:3

Click here for Foam Coat System mixing details and user tips.

Click here for Foam Coat System complete details.

WARRANTY: HWFF Inc./dba Hot Wire Foam Factory warrants this product to be of merchantable quality when used or applied in accordance with the instructions herein. The product is not warranted as suitable for any purpose or use other than the general purpose for which it is intended. Liability under this warranty is limited to the replacement of its product (as purchased) found to be defective, or at the shipping companies’ option, to refund the purchase price. In the event of a claim under this warranty, notice must be given to The Hot Wire Foam Factory in writing. This limited warranty is issued and accepted in lieu of all other express warranties and expressly excludes liability for consequential damages. MSDS available.