I've been using this for a couple weeks now, almost exclusively on foam. It holds very well and seems pretty sturdy. It dries within about a minute but takes longer to fully cure.
It does make a lot of "glue wisps" while working, but these are not nearly as annoying as those from hot glue. If it gets on my fingers it is easy to clean off as well.
RC Guy
May 23, 2019
This customer purchased the item at our site.
Fantastic glue, I use it to bond balsa leading and trailing edge to my custom cut foam core wings. Best adhesion when you apply a smooth bead to one side, make contact then pull apart then re-attach . Instant bond which is permanent after glue has cured. Cannot pull apart without breaking the balsa and foam. Never had a glue failure yet. Been using this glue for approximately 4 years. These wings are also subjected to moisture because the wings are built for water-based RC airplanes, meaning they can only fly off and land on water. Here is one of my planes taxing back to shore, second pic coming in for landing.
Angelina Ellis
Mar 12, 2019
This customer purchased the item at our site.
This glue is great. Dries pretty fast, and clean up is easy. I was easily able to cut through it with my hotwire tools. The glue holds together strong as well.
Stan Mockus
May 7, 2025
This customer purchased the item at our site.
To Whom This May Concern:
I have enjoyed working with StyroGoo on a lot of my RC Foam Airplane projects. Compared to Beacon's Foam Tac, it is more economical.
However, since one bottle has lasted me a long time, its viscosity has become a little heavier. Can you tell me which would be better to use to thin it out, alcohol or acetone?
Regards,
Stan Mockus
Edna Quichocho - Cal Poly Pomona
Feb 21, 2017
This customer purchased the item at our site.
Product is used by Arc. students. They like the way the product dries and the pricing of the product.
