Create Coat (3lbs) #027
Protects and Beautifies
New, creamy-smooth white rock-hard cement-like foam finish coat. Use directly on foam. Easy to make it look just like wood, stone, metal and bone. Perfect base for creating gorgeous natural tints with acid stains or our StainFast water based stain system. Does not stick to itself nearly as well as our other coatings do. Rough sand surface between coats. Use indoors or out. Fire, rain, freeze, and sun resistant.
Coat it • Smooth it • Texture it • Sand it • Stain it • Tint it
WARRANTY: HWFF Inc./dba Hot Wire Foam Factory warrants this product to be of merchantable quality when used or applied in accordance with the instructions herein. The product is not warranted as suitable for any purpose or use other than the general purpose for which it is intended. Liability under this warranty is limited to the replacement of its product (as purchased) found to be defective, or at the shipping companies’ option, to refund the purchase price. In the event of a claim under this warranty, notice must be given to The Hot Wire Foam Factory in writing. This limited warranty is issued and accepted in lieu of all other express warranties and expressly excludes liability for consequential damages. MSDS available.
Do you mix create coat with the exterior coat?
No you cannot mix them, but you can apply a layer of Create Coat over Exterior Foam Coat.
Keep in mind that subsequent coatings won't stick too well to Create Coat because it's super smooth and water resistant.
To be thrifty (Create Coat is more expensive than Exterior Foam Coat) and to get more strength, you can apply a single layer of Create Coat over All Purpose or Exterior Foam Coat
I'm trying to get a porcelain surface treatment for one of the sculptures. Not sure how to get that glassy stone finish?
If your sculpture is not too big, you can get a smooth finish by simply banging on your foam sculpture after you coat it. The foam coat will liquefy for an instant, smoothing out your brush strokes. You will definitely want to try this on a test piece first. Note: Create Coat won't stick well to itself without adding Boost, and once you add Boost it becomes super difficult to sand.
Create Coat can be smoothed as it dries. You can even use wet-and-dry sandpaper on it just before it hardens.
Average Customer Rating:
If you've already bought this product, please sign in and add your own review!